The MCP2562T-H/SN belongs to the category of integrated circuits (ICs) specifically designed for use in automotive applications.
This product is primarily used as a high-speed CAN transceiver. It provides an interface between a microcontroller and the physical two-wire CAN bus, allowing for reliable communication in automotive systems.
The MCP2562T-H/SN is available in tape and reel packaging, with a quantity of 2500 units per reel.
The MCP2562T-H/SN has a total of 8 pins, which are assigned specific functions:
The MCP2562T-H/SN operates based on the Controller Area Network (CAN) protocol. It receives data from the microcontroller and transmits it over the CAN bus using differential signaling. It also receives data from the bus and forwards it to the microcontroller. The transceiver ensures proper voltage levels and signal integrity, allowing for reliable communication between nodes in an automotive network.
The MCP2562T-H/SN is widely used in various automotive applications, including:
In conclusion, the MCP2562T-H/SN is a high-speed CAN transceiver designed for automotive applications. Its robustness, low power consumption, and small package size make it an ideal choice for various automotive electronic systems. However, it is important to consider alternative models based on specific application requirements.
What is the maximum data rate supported by MCP2562T-H/SN?
- The maximum data rate supported by MCP2562T-H/SN is 1 Mbps.
Can MCP2562T-H/SN be used in automotive applications?
- Yes, MCP2562T-H/SN is suitable for automotive applications as it meets AEC-Q100 standards.
What is the operating voltage range of MCP2562T-H/SN?
- The operating voltage range of MCP2562T-H/SN is 4.5V to 5.5V.
Does MCP2562T-H/SN support CAN FD (Flexible Data-Rate)?
- No, MCP2562T-H/SN does not support CAN FD.
Is MCP2562T-H/SN compatible with microcontrollers and microprocessors?
- Yes, MCP2562T-H/SN is compatible with a wide range of microcontrollers and microprocessors.
What is the typical quiescent current consumption of MCP2562T-H/SN?
- The typical quiescent current consumption of MCP2562T-H/SN is 8 mA.
Can MCP2562T-H/SN be used in industrial control systems?
- Yes, MCP2562T-H/SN is suitable for use in industrial control systems.
What is the common-mode voltage range of MCP2562T-H/SN?
- The common-mode voltage range of MCP2562T-H/SN is from -2V to 7V.
Does MCP2562T-H/SN have built-in ESD protection?
- Yes, MCP2562T-H/SN has built-in ESD protection up to ±15 kV HBM.
Is MCP2562T-H/SN available in a surface-mount package?
- Yes, MCP2562T-H/SN is available in a small outline SOIC package for surface-mount applications.